Stand Assembly - HP 205 G1 Maintenance & Service Manual

Stand assembly

Description
Stand assembly
The stand is secured with four Torx screws. You must remove the rear cover to remove the stand.
To remove the stand:
1. Prepare the computer for disassembly (see
2. Remove the rear cover (see
3. On the side of the rear cover, in the order stamped into the stand, remove the four Torx screws that
secure the stand to the rear cover (1).
4. Remove the stand from the rear cover (2).
To replace the stand, reverse the removal procedures.
Preparing to disassemble the computer on page
Rear cover on page 20).
Spare part number
752333-001
19).
Stand assembly 21