Os Installing - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

6. OS Installing

If the configurations of FCoE Boot that are described in previous chapters are properly done, a message
notifies that the connection to the target storage is established is displayed as shown in the figure below.
Legacy BIOS
[ ]
During the server restarts up, WWPN and LUN of the target storage are displayed as shown in the figure below.
UEFI
[ ]
In Boot Manager front page, select [Boot Manager] and press <Enter> key.
press <Enter> key to launch EFI shell.
If you see "blk0: BlockDevice" as shown in the figure below, the settings are completed.
Using SVIM (SeverView Install Manager), install OS of purpose.
Copyright 2016 FUJITSU LIMITED
Figure 6-1
Figure 6-2
41
Then select [EFI Internal Shell] and
CA92344-0966-01