Setting Of Pxe Boot Parameters; Pxeselect Utility (Legacy Mode) - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

Hide thumbs Also See for PRIMEQUEST 2000 Series:

Table of Contents

3. Setting of PXE Boot Parameters

This section describes the modification procedure of CNA Personality setup.

Screen images of the utility might look different with the firmware version of the CNA, although, the

items to be set to the utility are the same. Refer the screen images appropriately.

The following example shows Legacy mode.

You can change to Legacy mode from UEFI mode by Boot Maintenance Manager. (refer to 5.1 Section.)

During the system is starting up, if prompt of PXESelect Utility is displayed as shown below, then press <Ctrl> +

<P> key.

As Controller Configuration screen is displayed, set MultiChannel to DISABLED.

Figure 3-1

Figure 3-2

CA92344-0966-01

Table of Contents