Product Overview; Controls - Toro 22303 Dingo 320-D Operator's Manual

Product Overview

1. Mount
2. Tilt cylinder
3. Auxiliary hydraulic couplers
4. Loader arms
5. Front access cover

Controls

Become familiar with all the controls (Figure 6)
before you start the engine and operate the traction
unit.
Figure 6
1. Traction control levers
2. Attachment lift lever
3. Loader arm lever
4. Auxiliary hydraulics lever
Key Switch
The key switch, used to start and stop the engine,
has three positions: stop, run, and start.
Figure 5
6. Fuel tank
7. Wheel
8. Lift cylinder
9. Operator platform
10. Rear access cover (open)
5. Speed selector lever
6. Throttle lever
7. Key switch
8. Hour meter
11. Engine
12. Air lter
13. Control panel
14. Lift points
15. Handle
To start the engine, rotate the key to the start
position. Release the key when engine starts and it
will move automatically to the run position.
To stop the engine, rotate the key to the stop
position.
Throttle Lever
Move the control forward to increase the engine
speed and rearward to decrease speed.
Traction Control Levers
To move forward, move the traction control levers
forward. To move rearward, move the traction
control levers rearward.
To go straight, move both traction control levers
equally.
To turn, move the lever located on the side you
want to turn back toward the neutral position
while keeping the other lever engaged.
The farther you move the traction control levers
in either direction, the faster the traction unit will
move in that direction.
13
16. Battery
17. Indicator lights
18. Tow valves
19. Parking brake lever