Figure 15
1. Rear carrier frame
4. Secure each mounting link to the carrier frame with a
bolt (3/8 x 2-1/4 inch), 2 flat washers, and a locknut,
as shown in Figure 16. Position a washer on each
side of the link when mounting. Torque the fasteners
to 31 ft-lb (42 N-m).
Figure 16
1. Carrier frame
2. Mounting link
3. Plug
10
Mounting the Cutting Units
No Parts Required
Procedure
1. Slide a thrust washer onto each front lift arm pivot
rod.
2. Slide the cutting unit carrier frame onto the pivot
rod and secure it with a lynch pin (Figure 17).
Note: On rear cutting unit, position the thrust
washer between the rear of the carrier frame and
the lynch pin.
1. Thrust washer
2. Carrier frame
3. Grease all the lift arm and carrier frame pivot points.
Important: Ensure that the hoses are free of
twists or sharp bends and that the rear cutting
unit hoses are routed as show in (Figure 18).
Raise the cutting units and shift them to the left
(model 03206). The rear cutting unit hoses must
not contact traction cable bracket. Reposition
the fittings and/or hoses, if necessary.
19
Figure 17
3. Lynch pin