Figure 26
1. Rear cylinder
B. Grasp the cylinder rod close to the nut with a
pliers and rag and rotate the rod.
C. Raise the cutting units and check the clearance.
D. Repeat steps 1 through 3 if necessary.
E. Tighten the clevis jam nut.
Important: Lack of clearance at the front stops or
the rear wear bar could damage the lift arms.
2. Adjusting nut
Product Overview
Controls
1. Forward traction pedal
2. Reverse traction pedal
3. Mow/transport slide
Traction Pedals
Press the traction forward pedal (Figure 27) to move
forward. Press traction reverse pedal (Figure 27) to
move backward or to assist in stopping when moving
forward. Also, allow the pedal to move or move it to the
neutral position to stop the machine.
Mow/Transport Slide
Using your heel, move the mow/transport slide
(Figure 27) to the left to transport and to the right to
mow. The cutting units will only operate in the mow
position.
Important: The mow speed is set at the factory to
6 mph (9.7 km/h). It can be increased or decreased
by adjusting the speed stop screw (Figure 28).
1. Speed stop screw
22
Figure 27
4. Tilt steering lever
5. Indicator slot
6. Angle indicator
Figure 28