Table of Contents
Advertisement
1. Cruise control (optional)
2. Light switch
3. Hi-Lo speed control
4. Throttle control
5. Glow plug indicator light
6. Engine coolant
temperature warning
light
7. Diagnostic light
Engine Coolant Temperature Gauge
During normal operating conditions the gauge (Figure 4)
should be in the green range. Check the cooling system if the
gauge goes to the yellow or red range.
Engine Oil Pressure Warning Light
The light (Figure 4) illuminates when the engine oil pressure
is dangerously low.
Charge Indicator
The charge indicator (Figure 4) illuminates when the system
charging circuit malfunctions.
Key Switch
The key switch (Figure 4) has three positions: Off,
On/Preheat, and Start.
PTO Switch
The PTO switch (Figure 4) has two positions: Out (start)
and In (stop). Pull the PTO button out to engage the cutting
unit blades. Push in the button to disengage the cutting unit
blades.
Figure 4
8. Engine coolant
temperature gauge
9. Engine oil pressure
warning light
10. Charge indicator
11. Key switch
12. PTO switch
13. Flow divider switch
(optional)
14. Lift switches
Flow Divider Switch (optional)
When operating in mow (low) speed, press and hold
flow divider switch (Figure 4) to enhance traction drive
performance in compromised operating conditions.
Hi-Lo Speed Control
The switch (Figure 4) allows the speed range to increase for
transport of the machine. Cutting decks will not operate
in high range. Also, the decks cannot be lowered from the
transport position when the switch is in the high range. If
the switch is moved from LO to HI with the cutting decks
down and/or PTO on and/or cruise control engaged, the
transmission will not change to HI. For the change to be
accomplished, the switch must be moved to LO and all the
requirements satisfied.
Lift Switches
The lift switches (Figure 4) raise and lower the cutting
units. Press the switches forward to lower the cutting units
and backward to raise the cutting units. When starting the
machine, with the cutting units in the down position, press the
lift switch down to allow the cutting units to float and mow.
Note: The decks will not lower while in the HI speed range
and they will not raise or lower if the operator is out of the
seat when the engine is running.
Throttle Control
Move the control (Figure 4) forward to increase the engine
speed and rearward to decrease the speed.
Light Switch
Press the lower edge of the switch (Figure 4) to turn on the
lights. Press the upper edge of the switch to turn off the lights.
Glow Plug Indicator Light
When lit, the glow plug indicator light (Figure 4) indicates
that the glow plugs are on.
Engine Coolant Temperature Warning
Light
The light (Figure 4) illuminates and the cutting units shut
down (PTO disengages) if the engine reaches an unsafe
operating temperature. If the temperature continues to rise
the engine will shut down.
Engine Cooling Fan Switch
The machine is equipped with a hydraulically driven auto
reversing engine cooling fan. The fan switch (Figure 5) has
15
Advertisement
Table of Contents
