Toro 30447N Operator's Manual page 24

onto the spindle shaft to get the desired height-of-cut;
then slide the washer onto the shaft.
Figure 20
1. Tensioning cap
2. Spacers
3. Shims
Refer to the following chart to determine the
combinations of spacers for the setting.
Figure 21
3. Push the castor spindle through the castor arm. Install
the shims (as originally installed) and the remaining
spacers onto the spindle shaft. Install the tensioning
cap to secure the assembly.
4. Remove the hairpin cotter and clevis pins from the
castor pivot arms (Figure 22).
5. Rotate tension rod to raise or lower pivot arm
until holes are aligned with selected height-of-cut
bracket holes in the cutting unit frame (Figure 22 and
Figure 23).
6. Insert the clevis pins and install the hairpin cotters.
7. Rotate tension rod counterclockwise (finger tight) to
put tension on adjustment.
4. Top axle mounting hole
5. Castor wheel
1. Castor pivot arm
2. Axle mounting holes
Adjusting the Skids
The skids should be mounted in the lower position when
operating in height of cuts greater than 2-1/2 inches (64 mm)
and in the higher position when operating in height of cuts
lower than 2-1/2 inches (64 mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 24).
1. Skid
24
Figure 22
3. Clevis pin and hair pin
cotter
4. Tension rod
Figure 23
Figure 24