Table of Contents
Advertisement
Figure 55
1. Water separator filter canister
3. Clean the area where the filter canister mounts.
4. Remove the filter canister and clean the mounting
surface.
5. Lubricate the gasket on the filter canister with clean oil.
6. Install the filter canister by hand until the gasket
contacts mounting surface, then rotate it an additional
1/2 turn.
7. Tighten the drain plug on the bottom of the filter
canister.
Bleeding Air from the Injectors
1. Loosen the tube connection to the Number 1 injector
nozzle and holder assembly at the injection pump
(Figure 56).
Figure 56
1. Number 1 injector nozzle
2. Move the throttle to the Fast position.
3. Turn the key in the ignition switch to the Start position
and watch the fuel flow around the connector. Turn
the key to the Off position when solid flow is observed.
4. Tighten the tube connector securely.
5. Repeat the procedure on the remaining nozzles.
Electrical System
Maintenance
Battery Care
Battery type is group 24.
Important: Before welding on the machine, disconnect
the negative cable from the battery to prevent damage to
the electrical system.
Note: Check the battery condition weekly or after every
50 hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge slowly.
To clean the battery, wash the entire case with a solution
of baking soda and water. Rinse with clear water. Coat
the battery posts and cable connectors with Grafo 112X
(skin-over) grease (Toro Part No. 505-47) or petroleum jelly
to prevent corrosion.
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
1. Raise the seat and secure it with the prop rod.
2. Remove the battery cover (Figure 57).
1. Battery cover
38
WARNING
Figure 57
Advertisement
Table of Contents
