•
Front and rear axle pivot bushings (2) (Figure 39)
•
Steering cylinder ball joints (2) (Figure 40)
•
Tie rod ball joints (2) (Figure 40)
•
King pin bushings (2) (Figure 40).
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 37
Figure 38
Figure 39
Center Cutting Unit
Note: Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
•
Latch pivot (2) (Figure 42)
Note: The latch (Figure 41) may need to be manually
tripped to gain access to the grease fitting. Use a prybar
to close and re-open the latch
1. Latch
33
Figure 40
Figure 41