Premaintenance
Procedures
Inner Wing Deck Covers
Removal
1. Lower the wing deck onto a level surface.
2. Disengage the cover latch.
3. Remove the bolt securing the belt cover, if so
equipped.
4. Lift the rear and inside cover edges off the mounting
posts (Figure 46).
Figure 46
1. Mounting posts
5. While lifting the cover, slide it toward the traction
unit, approximately 1 inch, to disengage the outer
cover edge from the deck (Figure 47).
Figure 47
1. Slide cover inward
approximately 1 inch
6. Lift the front edge, guide it between the lift arm and
the roller to remove it (Figure 48).
2. Disengage these cover
edges
1. Slide cover out between lift arm and roller
Installation
1. Lower the wing deck onto a level surface.
2. Slide the cover into position by guiding the rear edge
between the lift arm and roller.
3. While sliding the cover away from the traction unit,
guide the outside edge under the front and rear
brackets on the deck.
4. Align the deck mounting posts with the holes in the
cover and lower the cover into position.
5. Install the bolt securing the belt cover, if so equipped.
6. Engage the deck cover latch.
42
Figure 48