Light Switch; Seat Adjustments - Toro 31598 Operator's Manual

the cruise control, the middle position of the switch
enables the cruise control function and the front of the
switch sets the desired ground speed.
Note: Pressing either brake pedal or moving the
traction pedal into the reverse position, for one second,
will also disengage the cruise control.

Light Switch

Press the lower edge of the switch (Figure 11) to turn on
the lights. Press the upper edge of the switch to turn
off the lights.
Audible Alarm (Console)
The alarm is activated when a fault is detected.
The buzzer sounds:
• continuous when the engine sends a stop fault.
• with a short pulse when the engine sends a check
engine fault.
• when there is low fuel.
Power Point
The power point, located next to the console on the side
of the power center, is used to power optional electrical
accessories (Figure 11).

Seat Adjustments

Weight gauge
Indicates when the seat is adjusted to the weight of
the operator (Figure 12). Height adjustment is made
by positioning the suspension within the range of the
green region.
1. Weight gauge
2. Weight adjusting lever
3. Fore and Aft adjusting
lever
Weight Adjusting Lever
Adjust for operator weight (Figure 12). Pull up on the
lever to increase the air pressure and push down to
decrease the air pressure. The proper adjustment is
attained when the weight gauge is in the green region.
Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft
(Figure 12).
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle (Figure 12).
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle
(Figure 12).
21
Figure 12
4. Seat back adjusting lever
5. Arm rest adjusting knob