Work Light Switch (Machines With Operator Cab-Optional) - Toro Groundsmaster 360 Service Manual

Work Light Switch (Machines with Operator Cab–Optional)
Testing the Work Light Switch
Groundsmaster 360
16225SL Rev C
g186594
1. Work light switch (optional)
2. Beacon switch (optional)
g037935
The switches are located in the cab headliner
used to turn the optional light kits on and off.
1. Park the machine on a level surface, lower the cutting deck, and shut off the
engine. Remove the key from the key switch.
2. To access the switch, remove the roof panel from the top of the cab; refer to
Roof Assembly (page
3. Remove the lights switch panel from the cab headliner.
4. Disconnect the machine wire harness connector from the switch that you
are testing.
5. The switch terminals are identified in
switch is shown in the
multimeter (ohms setting), test the switch functions to determine if continuity
exists between the various terminals for each switch position. Check the
continuity between the switch terminals.
Circuit Logic Table
Switch Position
O
FF
O
N
Figure 220
3. Cab headliner (lights switch panel)
Figure 221
(Figure
8–10).
Figure 221
Circuit Logic Table (page
Closed Circuits
2+1 and 5+4
2+3 and 5+6
Page 5–77 Electrical System: Testing the Electrical Components
220). The switches are
and the circuitry of the
5–77). With the use of a
Open Circuits
2+3 and 5+6
2+1 and 5+4