Toro Groundsmaster 360 Service Manual page 43

Removing the Exhaust System
Installing the Exhaust System
Groundsmaster 360
16225SL Rev C
A hot engine and exhaust system can cause burns.
Allow the engine and the exhaust system to cool before working
on or near them.
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Unlatch the hood and raise it.
3. Remove the exhaust tube as shown in
Note: The exhaust system DPF and DOC can be removed from the exhaust
system without removing the entire exhaust system from the engine. Refer to
the Yanmar Engine Service Manual for complete disassembly and assembly
procedures.
1. Install the exhaust tube as follows:
A. Install all the fasteners finger tight.
B. Starting at the bottom, tighten the flange nuts (item 5 in
C. Tighten the lower exhaust clamp.
D. Tighten the upper exhaust clamp.
2. Lower the hood and secure it with the latches.
CAUTION
Figure
Page 3–11
9.
Figure 9).
Diesel Engine: Service and Repairs