Toro Groundsmaster 360 Service Manual page 189

Installing the CrossTrax Traction Manifold Assembly (continued)
Groundsmaster 360
16225SL Rev C
g036302
1. Traction manifold assembly
2. Transmission
1. If an orifice was removed from any port, ensure that the orifice is in the
port before you install the fitting; refer to
Manifold Assembly (page
2. If the hydraulic fittings were removed from the traction manifold assembly,
lubricate new O-rings with clean hydraulic fluid, position the O-rings to the
fittings, and install the fittings into the ports; refer to
Fittings (SAE Straight Thread O-Ring Fitting into the Component Port) (page
4–9).
3. Position the traction manifold assembly to the machine.
4. Position the 2 washers (item 9 in
Secure the traction manifold assembly to the machine with 2 bolts and 2
washers (item 7 in
5. Remove the caps and plugs from the hydraulic hoses and fittings.
Note: The hoses in ports LR and RR should be installed in the traction
manifold ports before they are installed to the hydraulic tubes.
6. Use the labels that you attached during traction manifold assembly removal,
correctly connect the hydraulic hoses to the traction manifold assembly and
hydraulic tubes (Figure
(O-Ring Face Seal Fitting) (page
7. Check the hydraulic-fluid level in the hydraulic reservoir and add correct
quantity of fluid if necessary; refer to the Operator's Manual.
8. Lower and secure the operator seat.
Figure 134
3. Hose to port LR
4. Hose to port RR
Servicing the CrossTrax Traction
4–132).
Figure 133) to the top of the mounts.
Figure 133).
134); refer to Installing the Hydraulic Hose and Tube
4–8).
Page 4–131
Installing the Hydraulic
Hydraulic System: Service and Repairs