Toro Groundsmaster 360 Service Manual page 431

Removing the Blade Spindle (continued)
Installing the Blade Spindle
Groundsmaster 360
16225SL Rev C
4. Remove the drive belt from the deck pulleys; refer to the Cutting Deck
Operator's Manual.
5. Remove the cutting blade, anti-scalp cup, and blade bolt from the spindle
(Figure 306).
6. Remove the 8 ribbed neck bolts and 8 flange nuts that attach the spindle
assembly to the deck, and remove the spindle assembly from the deck.
1. Position the spindle on the cutting deck and note the orientation of the grease
fitting (Figure 307). Attach the spindle assembly to the deck with the 8 ribbed
neck bolts and 8 flange nuts.
2. Install the cutting blade, anti-scalp cup, and blade bolt
the blade bolt to 119 to 146 N∙m (88 to 108 ft-lb).
3. Slowly rotate the cutting blades to check that the blades do not contact any
deck component(s).
4. Install the drive belt to the deck pulleys.
5. Lubricate the spindle grease fittings.
6. Install the belt covers to the cutting deck.
7. Lower the footrest.
Page 7–11
(Figure 306); torque
Cutting Deck: Service and Repairs