Toro Groundsmaster 360 Service Manual page 269

Using the InfoCenter Display for Troubleshooting (continued)
Groundsmaster 360
16225SL Rev C
In the Decks operation example, the following qualifiers must be in the
desired condition ( ) before any operation Outputs can be energized:
• Operator must be in seat (seat switch)
• Parking brake O
If and do not alternate when the qualifier condition is changed, the
qualifier or the circuit wiring for the qualifier is damaged and should be tested
as described.
8. Press the menu/back button (as indicated by the
screen). Select (highlight) the Outputs and press the left/right button (as
indicated by the
9. If all the Inputs are O
the Outputs for the machine operation should be O
O , the Toro Electronic Controller (TEC) or TEC software may be damaged
FF
and require reloading or replacement. Contact your Toro Distributor for
assistance.
10. If the outputs listed on the InfoCenter Display are O
is still malfunctioning:
• Test the specific output and output wiring; refer to
Components (page
• Test the hydraulic components related to the operation; refer to
4: Hydraulic System (page
In the Decks operation example, the outputs are the solenoid valve SV1
for cutting deck raise and solenoid valve SV2 for cutting deck float. If O
appears next to these outputs on the InfoCenter Display:
• Test the hydraulic solenoid valve coils; refer to
Coils (page 5–91).
• Perform cutting deck hydraulic circuit tests; refer to
System (page 4–1).
FF
at the bottom of the screen).
and all the Qualifiers are in their desired condition ( ),
N
5–49).
4–1).
Page 5–33
at the bottom of the
. If the outputs remain
N
, and the operation
N
Testing the Electrical
Chapter
Hydraulic Solenoid Valve
Chapter 4: Hydraulic
Electrical System: Troubleshooting
N