Toro Groundsmaster 360 Service Manual page 413

Removing the Operator Seat (continued)
Installing the Operator Seat
Groundsmaster 360
16225SL Rev C
5. Support the seat and upper seat plate (item 8 in
from shifting during seat removal.
6. Remove the 4 carriage screws (item 7 in
secure the seat and upper seat plate assembly to the seat plate, and remove
the seat and upper seat plate from the machine.
7. Remove the seat parts as shown in
1. Install all the removed seat parts
2. If the seat belt (item 3 in
seat assembly, apply blue gel thread locker (or equivalent) to the threads of
the bolt before installing the screw.
3. If the seat plate (item 14 in
to the machine as shown in
4. Position the seat and upper seat plate assembly to the seat plate. Secure the
assembly with the 4 carriage screws (item 7 in
5. Install the seat assembly to machine as follows:
A. Position entire seat assembly onto the machine and secure with the
clevis pins and hairpins.
B. Raise the seat and connect the prop strap to the seat plate.
C. Secure the prop strap to the seat plate with the flat washer and hairpin.
6. Connect the wire harness electrical connector to the seat switch harness
(Figure 298).
7. Lower the seat and latch it.
8. Check the operation of the operator seat switch.
Figure
Figure
(Figure 297).
Figure 297) or seat belt latch were removed from the
Figure 297) was removed, secure the seat plate
Figure 297.
Page 6–61
Figure 297) to prevent them
297) and 4 flange nuts that
297.
Figure 297) and 4 flange nuts.
Chassis: Service and Repairs