Toro Groundsmaster 360 Service Manual page 286

Testing the Fusible Link Harness
Electrical System: Testing the Electrical Components
stops; refer to the Electrical Schematics in
Drawings for additional circuit information.
1. Ensure that the key switch is in the O
battery cable from the battery terminal, and then disconnect the positive
cable from the battery; refer to
2. Locate and unplug the fusible link connector P1 from the machine wire
harness.
3. Use a multimeter to ensure that the continuity exists between each terminal
pin in the connector P1 and connector J1 at the starter
4. If any of the fusible links are open, replace the fusible link harness.
Note: Before installing a new fusible link harness, ensure any conditions that
may have damaged the fusible links have been identified and repaired.
5. After you complete the testing, ensure that the fusible link harness connectors
are correctly attached to the starter and machine wire harness. Connect the
positive battery cable to the battery terminal and then connect the negative
cable to the battery.
Appendix A (page
position, disconnect the negative
FF
Servicing the Battery (page
Page 5–50
A–1)—Foldout
5–110).
(Figure 194).
Groundsmaster 360
16225SL Rev C