Toro Groundsmaster 360 Service Manual page 213

Assembling the Steering Cylinder (continued)
Groundsmaster 360
16225SL Rev C
Ensure that you do not damage O-ring (item 7 in
piston is installed over the roll pin hole in the front rod.
3. Install the piston (item 13 in
ring onto the front rod.
When installing the roll pin into the front and rear rods, ensure that
the rod surfaces are not damaged.
4. Slide the rear rod onto the front rod and align the roll pin holes in the rods.
Install roll pin (item 6 in
When clamping the cylinder's barrel in a vise; clamp on the clevis
only to prevent damage. Do not close the vise on the barrel or rods.
5. Mount the steering cylinder barrel in a vise equipped with soft jaws by
clamping on the barrel clevis.
Note: Do not damage the seals during installation.
6. Coat all the internal cylinder components with clean hydraulic fluid. Slide the
rod assembly into the barrel.
Note: Do not damage the head seals during installation.
7. Insert the rear head with new seals into the barrel.
8. Secure the front and rear heads in the barrel with external collars, tighten
the collars with a spanner wrench.
IMPORTANT
Figure 148) with new seal, O-ring, and wear
IMPORTANT
Figure 148) to secure the rods.
IMPORTANT
Page 4–155
Figure 148) as
Hydraulic System: Service and Repairs