Troubleshooting; Operator Advisories - Toro Groundsmaster 360 Service Manual

Troubleshooting

Operator Advisories

Electrical System: Troubleshooting
Remove all the jewelry, especially rings and watches, before doing
any electrical troubleshooting or testing. Disconnect the battery
cables unless the test requires battery voltage.
For the effective troubleshooting and repairs, you must have a good
understanding of the electrical circuits and components that are used
on this machine; refer to the Electrical Schematics and Wire Harness
Drawings/Diagrams in
If the machine has any interlock switches that are bypassed, connect the
switches for the correct troubleshooting and safety.
Note: Use the InfoCenter display when troubleshooting a Groundsmaster 360
electrical problem.
The list below identifies the operator advisories that are generated by the TEC.
An advisory will be displayed on the InfoCenter display. Typically, an advisory
can be eliminated with a change in the machine controls by the operator.
Advisory
160
161
172
169
Advisory Qualifiers
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
178
179
CAUTION
Appendix A (page A–1)—Foldout Drawings.
Page 5–28
Advisory Description
Inhibit start
Inhibit PTO
4WS/2WS transition
Safety shutdown
Advisory Qualifiers Description
Version check restriction
Sit down or set parking brake
Machine not in neutral
Front lift switch closed
Front lower switch closed
Front left angle switch closed
Front right angle switch closed
Lift switch on joystick closed
Lower switch on joystick closed
Deck raise switch closed
Deck lower switch closed
Not in seat
Blower switch closed
Decks not floating
Engine is overheating
Requalify PTO
PTO switch is ON
Groundsmaster 360
16225SL Rev C