Toro Groundsmaster 360 Service Manual page 343

Removing the Hydraulic Solenoid Valve Coils
Installing the Lift Control Manifold Solenoid Valve Coils
Groundsmaster 360
16225SL Rev C
You can replace a hydraulic solenoid valve coil on the deck lift manifold
248) or steering selector manifold
system.
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, shut off the engine, and remove the key from the key switch.
2. Locate the solenoid valve coil that you replace.
A. Raise the operator seat to get access to the deck lift manifold
248) for the location of solenoid coils on the deck lift manifold.
B. Raise the operator seat to get access to the steering selector manifold
(Figure 249) for the location of solenoid coils on the steering selector
manifold.
3. Disconnect the wire harness electrical connector from the solenoid valve
coil that you replace.
4. Remove the nut from the hydraulic valve.
5. Slide the solenoid coil from the valve.
6. Clean any corrosion or dirt from the valve.
1. Slide the coil assembly onto the hydraulic valve.
2. Install the nut onto the valve and torque the nut to 6.8 N∙m (60 in-lb).
Note: Do not overtighten the nut.
3. Connect the machine wire harness connector to the solenoid coil.
4. Lower and secure the seat.
(Figure 249) without opening the hydraulic
Page 5–107
(Figure
(Figure
Electrical System: Service and Repairs