Toro Groundsmaster 360 Service Manual page 397

Removing the PTO Driveshaft (continued)
Groundsmaster 360
16225SL Rev C
g037445
1. Transmission
2. Bolt
3. PTO driveshaft
2. Disconnect the wire harness electrical connector from the PTO solenoid
valve coil connector (item 2 in
engaging unintentionally.
3. Disconnect the end yoke of the PTO driveshaft (item 3 in
the PTO shaft on transmission as follows:
A. Remove the roll pin from the end yoke and PTO shaft.
B. Loosen the 2 bolts and the 2 locknuts.
C. Slide the driveshaft end yoke from the PTO shaft.
4. Disconnect the end yoke of PTO driveshaft from the cutting deck gearbox
shaft as follows:
A. Remove the roll pin from the end yoke and gearbox shaft.
B. Loosen the 2 bolts and the 2 locknuts.
C. Slide the driveshaft end yoke from the gearbox shaft.
5. Remove the PTO driveshaft from the machine.
Figure 286
4. Locknut
5. Roll pin
6. PTO shaft
Figure 285) to prevent the PTO clutch from
Page 6–45
Figure 286) from
Chassis: Service and Repairs