Aligning The Wheels - Toro Groundsmaster 360 Service Manual

Aligning the Wheels

Chassis: Adjustments
1. Park the machine on a level surface with the wheels directed straight ahead.
Lower the cutting deck, shut off the engine, set the parking brake, and
remove the key from the key switch.
Note: Machine handling issues may be caused by improper or unbalanced
tire pressures. Ensure that all tire pressures (front and rear) are properly
adjusted before checking or adjusting the wheel alignment; refer to
Specifications (page
g036463
1. Front cover
2. Screw (2 each)
3. Flat washer (2 each)
g037251
1. Jam nut
2. Remove the front cover from the front axle to get access to the front steering
components (Figure
3. Raise the operator seat and lower the power center assembly to get access
to the rear steering components; refer to
without Operator Cab) (page 6–55)
with Operator Cab) (page
6–2).
Figure 255
4. Grommet (2 each)
5. Tinnerman nut (2 each)
6. Front axle
Figure 256
2. Rod end
255).
Power Center Assembly (Machines
and Power Center Assembly (Machines
6–57).
Page 6–8 Groundsmaster 360
16225SL Rev C