Toro Groundsmaster 360 Service Manual page 404

Assembling the Cutting Deck Lift Assembly (continued)
Chassis: Service and Repairs
the second flange nut to 68 N∙m (50 ft-lb). When you install the chain to
the rear lift arm; torque the bolts to 68 N∙m (50 ft-lb).
3. Lubricate all the lift arm grease fittings after assembly.
4. Start the engine and fully raise the cutting deck. Shut off the engine and
remove the key from the key switch.
5. Install the HOC pin into the HOC bracket to allow desired height-of-cut.
Page 6–52 Groundsmaster 360
16225SL Rev C