Toro Groundsmaster 360 Service Manual page 172

Assembling the Transmission
Hydraulic System: Service and Repairs
g033449
1. Swash plate (2 each)
2. Washer
Note: When assembling the transmission, lubricate all the transmission
components with clean hydraulic fluid.
1. Ensure that all the transmission components are clean before you assemble
the transmission.
2. Apply clean hydraulic fluid to the washers and surfaces of the swash plate.
Install the washer onto each swash plate and carefully install the swash
plates into the transmission pump housing.
g033448
1. Side cover
2. O-ring
3. Pump housing
3. Press the oil seal into the 2 side covers and secure the seal with the retaining
ring. Lubricate new O-rings and install them onto the side covers.
4. Carefully slide the side covers over the trunnion shaft.
Note: Ensure that you do not damage the seals.
5. Install the 2 side covers to the transmission pump housing with the 3
socket-head screws; torque the screws to 8.8 to 10.8 N∙m (78 to 95 in-lb).
Figure 105
3. Pump housing
Figure 106
4. Retaining ring
5. Oil seal
Page 4–114 Groundsmaster 360
16225SL Rev C