Aligning the Wheels (continued)
Groundsmaster 360
16225SL Rev C
g037245
1.
Straight edge
2.
Front wheel
9. If the straight edge does not contact the tires at 4 points, adjustments to the
tie rods are necessary to align the wheels
A. Loosen the jam nut on the tie rod and rotate the inner tie rod end to
adjust the wheel alignment.
B. Repeat the tie rod adjustment for the front and rear wheels as necessary.
C. When the front and rear wheels are aligned, tighten the tie rod jam nuts
to 68 N∙m (50 ft-lb).
10. After the tie rod adjustment has been completed, ensure that the straight
edge contacts the front and rear tires at 4 points. Repeat the tie rod
adjustment if necessary.
11. Use the rigid straight edge, repeat the steps
of the machine.
Figure 259
3.
Rear wheel
4.
Tire contact point
(Figure
Page 6–11
260).
8
through
10
for the other side
Chassis: Adjustments