Toro Groundsmaster 360 Service Manual page 362

Aligning the Wheels (continued)
Chassis: Adjustments
g037244
1. Front axle
2. Front center link
6. Secure the rear alignment tool (refer to
axle and center link
align the rear steering components with the alignment tool before securing
the tool to the machine.
7. Secure the front alignment tool (refer to
front axle and the center link
steering components with the alignment tool, loosen the hydraulic hoses on
the front steering cylinder to allow the front cylinder movement independent
of the rear steering cylinder. Then, use a large adjustable wrench to rotate
the front steering arm so that the front steering components are aligned
with the alignment tool.
8. With both alignment tools installed, place a rigid straight edge (e.g., angle
iron, metal pipe) that is at least 2 m (80 inches) long against the sides of the
front and rear tires on one side of the machine
edge should contact the tires at 4 points if the wheel alignment is correct.
Figure 258
3. Front alignment tool
4. Front steering arm
Special Tools (page
(Figure 257). If necessary, use the steering wheel to
Special Tools (page
(Figure 258). If necessary to align the front
Page 6–10
6–4)) to the rear
6–4)) to the
(Figure 259). The straight
Groundsmaster 360
16225SL Rev C