Toro Groundsmaster 360 Service Manual page 169

Disassembling the Transmission (continued)
Groundsmaster 360
16225SL Rev C
g033444
1. Seal ring (2 each)
2. PTO shaft
3. B-plate
4. C-plate
57. Disassemble the PTO shaft assembly as follows:
A. Use a bearing puller to remove the bearing from the PTO shaft. Discard
the bearing.
B. Remove the spacer from the PTO shaft.
C. Slide the gear and clutch assembly from the PTO shaft.
D. Remove the key from the PTO shaft slot.
E. Remove the 2 seal rings from the PTO shaft grooves. Discard the seal
rings.
F. Remove the B-plate, C-plate, 3 A-plates, and 3 friction plates from the
PTO shaft.
G. Use a bearing puller to remove the bearing from the PTO shaft. Discard
the bearing.
g033445
1. Rod (3 each)
2. Clutch assembly
58. Slide the 3 rods from the holes in the clutch assembly.
59. Slide the PTO gear assembly from the clutch assembly.
Note: Because the individual clutch components are not available,
disassembly of the clutch assembly is not necessary.
Figure 99
5. A-plate (3 each)
6. Friction plate (3 each)
7. Bearing
Figure 100
3. PTO gear assembly
Page 4–111 Hydraulic System: Service and Repairs