Fuel Pump - Toro Groundsmaster 360 Service Manual

Fuel Pump

Testing the Fuel Pump Capacity
Groundsmaster 360
16225SL Rev C
The fuel pump is attached to the frame near the fuel/water separator
235). Electrical current is available for the fuel pump when the key switch is
in either the R or S
UN TART
The Toro Electronic Controller (TEC) energizes the fuel pump.
When testing the fuel pump, ensure that the pump is not operated
without fuel.
Diesel fuel is highly flammable.
• Use caution whenever you handle diesel fuel.
• Do not smoke while testing the fuel pump.
• Do not test the fuel pump while the engine is hot.
• Ensure that there is adequate ventilation when testing.
• Always wipe up any spilled diesel fuel before starting the engine.
g186520
1. Fuel/water separator
2. Pump discharge hose
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, and set the parking brake. Ensure that the key switch is in the O
position.
2. Unlatch the hood and raise it.
position.
IMPORTANT
DANGER
Figure 235
3. Fuel pump
Page 5–93 Electrical System: Testing the Electrical Components
(Figure
FF