Toro Groundsmaster 360 Service Manual page 54

Removing the Engine (continued)
Diesel Engine: Service and Repairs
3. Disconnect both the battery cables at the battery. Disconnect the negative
battery cable and then the positive battery cable; refer to
Battery (page 5–110).
4. Remove both the hydraulic hose guides (item 4 in
tube assembly.
5. Disconnect the air inlet hose from the radiator frame.
6. Disconnect the air inlet hose from the engine intake manifold.
7. Remove the cross tube with air cleaner assembly attached as shown in
Figure 15.
8. Remove the radiator and oil cooler assembly; refer to
(page 3–13).
9. Remove the fan shroud.
10. Disconnect the upper and lower radiator hoses from the engine.
11. Remove the clamp securing the oil cooler hydraulic tube to the machine
frame rail.
12. Remove the exhaust tube
13. Label all the electrical connectors to assure correct assembly. Note the
location of cable ties, anchors, and wire routing to assure correct assembly.
• Disconnect the negative battery cable from the engine block.
• Disconnect the Toro engine harness from Yanmar engine harness (4
multipin connectors on the left side of the engine).
• Disconnect the wire harness connector at the oil pressure switch.
• Disconnect the wire harness from the starter "S" terminal (item 5 in
16).
• Disconnect the wire harness from the alternator (items 6,7, and 8 in
16).
• Disconnect the wire harness from the DPF pressure sensor (item 3 in
Figure 16) and temperature sensors (items 1 and 2 in
• Disconnect the wire harness from the glow plug bus (item 4 in
• Disconnect the battery positive cable and fusible link harness from the
starter solenoid post.
14. For assembly purposes, label the fuel hoses. Disconnect the fuel supply
hose (item 1 in Figure
(Figure 9).
18) and return hose from the fuel filter on the engine.
Page 3–22
Servicing the
Figure 15) from the cross
Removing the Radiator
Figure
Figure
Figure 16).
Figure 16).
Groundsmaster 360
16225SL Rev C