Servicing The Wheel Motor - Toro Groundsmaster 360 Service Manual

Servicing the Wheel Motor

g036040
1. Locknut
2. Dirt and water seal
3. Housing assembly
4. Back-up ring
5. Back-up washer
6. Shaft seal
7. Square key
Groundsmaster 360
16225SL Rev C
8. Coupling shaft
9. Square ring seal (5 each)
10. Drive link
11. Thrust bearing
12. Wear plate
13. Rotor assembly
14. Manifold assembly
Note: The wheel motors of the Groundsmaster 360 machine have the same
basic construction. The left wheel motor(s) has a yellow dot on the port side of
the motor housing. The right wheel motor(s) has a reverse timed manifold.
Do not interchange the wheel motors on the machine (e.g., do not
put the right motor on the left side of the machine). If necessary, use
the Parts Catalog and Part Number on the wheel motor to identify
the right and left motors.
Note: For the wheel motor repair procedures; refer to the Parker Torqmotor™
Service Procedure (TC, TB, TE, TJ, TF, TG, TH, and TL Series) at the end of
this chapter.
Figure 67
15.
16.
17.
18.
19.
20.
IMPORTANT
Page 4–87
Commutator assembly
End cover
Bolt (7 each)
Identification tag
Drive screw (2 each)
Commutator seal
Hydraulic System: Service and Repairs