Toro Groundsmaster 360 Service Manual page 165

Disassembling the Transmission (continued)
Groundsmaster 360
16225SL Rev C
38. Remove the thrust plate from each swash plate. For assembly purposes,
note that the beveled sides of the thrust plates are against the swash plate
surfaces.
39. Remove the socket-head screw and nut that secures the control arm onto
each trunnion shaft. Slide the control arm from each trunnion shaft.
g033437
1. Hex plug
40. Remove the 2 hex plugs and 1 socket-head plug from the gear case housing.
41. Remove and discard the O-rings from the plugs.
g033438
1. Gear case housing
2. Pump housing
42. Remove the 15 flange-head screws that attach the gear case housing to the
transmission pump housing.
43. Carefully remove the gear case housing from the pump housing.
44. Locate and retrieve the 2 pins from the gear case housing holes.
45. Remove and discard the gasket.
Figure 92
2. Socket-head plug
Figure 93
3. Pin (2 each)
Page 4–107 Hydraulic System: Service and Repairs