Toro Groundsmaster 360 Service Manual page 341

Removing the PTO Solenoid Valve Coil
Installing the PTO Solenoid Valve Coil
Groundsmaster 360
16225SL Rev C
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, shut off the engine, and remove the key from the key switch.
2. Raise the operator seat to get access to the PTO solenoid valve coil.
3. Disconnect the wire harness electrical connector from the PTO solenoid
valve coil connector.
4. Remove the nut from the spool assembly.
5. Slide the coil assembly from the solenoid valve stem
6. Clean any corrosion or dirt from the valve stem.
1. Slide the new coil assembly, seals, and washers onto the solenoid valve stem.
Ensure that you correctly position the seals and washers
should be installed so the "KANZAKI" molded into the coil has the "I" nearest
the nut location as coil direction is important for proper solenoid operation.
When securing the solenoid valve coil to the solenoid, do not
overtighten the hex nut.
2. Install the hex nut onto the spool assembly and torque the nut to 5.9 to 7.8
N∙m (53 to 69 in-lb).
3. Connect the wire harness electrical connector to the solenoid valve coil
connector.
4. Lower and secure the operator seat.
IMPORTANT
Page 5–105
(Figure 247).
(Figure 247). Coil
Electrical System: Service and Repairs