Toro Groundsmaster 360 Service Manual page 333

Testing the Resistor Assembly
Groundsmaster 360
16225SL Rev C
A 75 ohm resistor (Figure
key switch connector; refer to the Electrical Schematics and Wire Harness
Drawings/Diagrams in
is necessary for proper key switch operation.
The engine wire harness also contains a 1600 ohm resistor
This resistor is used in all the engine wire harnesses for Groundsmaster 360
machines that is necessary for operating the key switch. The resistor plugs into
the wiring harness near the alternator; refer to the Engine Wire Harness Drawing
in Appendix A (page A–1)—Foldout Drawings.
The resistor assembly can be identified by its gray color and resistor symbol on
the end of the resistor assembly body.
The resistor can be tested using a digital multimeter (ohms setting).
Note: The resistance across the resistor terminals should be 75 ohms or 1600
ohms depending on which resistor is tested.
238) plugs into the console wire harness near the
Appendix A (page A–1)—Foldout Drawings. This resistor
Page 5–97 Electrical System: Testing the Electrical Components
(Figure 239).