Toro Groundsmaster 360 Service Manual page 398

Installing the PTO Driveshaft
Chassis: Service and Repairs
g037446
1. End yoke
2. Cross and bearing set
3. Grease fitting
4. Yoke and shaft
1. Position the PTO driveshaft to the machine.
Note: Ensure that the driveshaft yoke and slip tube (item 6 in
toward the cutting deck gearbox shaft.
2. Align the splines and roll pin holes of the driveshaft yokes with the
transmission and gearbox shafts.
3. Slide the PTO driveshaft end yokes onto the transmission PTO shaft and
gearbox shaft.
4. Attach the end yokes of the PTO driveshaft as follows:
A. Install the 2 roll pins to the end yokes and shafts.
B. Install the 4 bolts in the driveshaft end yokes. Alternate direction that
the bolt is installed on each yoke.
C. Install and tighten the 4 locknuts that attach the end yokes to the gearbox
and PTO shafts; torque the locknuts to 20 to 25 N∙m (175 to 225 in-lb).
5. Lubricate the PTO driveshaft grease fittings.
6. Connect the wire harness electrical connector to the PTO solenoid valve
coil connector (item 2 in
Figure 287
5. Grease fitting
6. Yoke and slip tube
7. End yoke
Figure 285).
Page 6–46
Figure 287) is
Groundsmaster 360
16225SL Rev C