Toro Groundsmaster 360 Service Manual page 471

Disassembling the Windshield Wiper Assembly
Assembling the Windshield Wiper Assembly
Groundsmaster 360
16225SL Rev C
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Remove the 2 bolts (item 2 in
wiper blade to the wiper arm assembly, and remove the wiper blade.
3. If necessary, remove the wiper arm assembly as follows:
A. Disconnect the washer hose from the wiper assembly.
B. Lift the caps at the top of the wiper arms and remove the flange nuts that
secure the wiper arms to the wiper motor.
C. Use a suitable puller to remove the tapered wiper arm sockets from the
wiper motor shafts.
4. If access to the wiper motor is necessary, remove the roof panel from the top
of the cab to get access to the wiper motor assembly; refer to
Roof Assembly (page
5. Remove the wiper motor components as shown in
1. If required, install the wiper motor components that were removed
334) and do the following:
A. If the wiper bracket (item 8 in
RTV sealant around the wiper opening on inside of the headliner before
you install the bracket.
B. Ensure that the wiper motor electrical connector is secured to the cab
wire harness.
C. Secure the roof panel to the top of the cab; refer to
Assembly (page
2. If the wiper arm assembly was removed, do the following:
A. Clean the tapered wiper arm sockets and wiper motor shafts.
B. Slide the wiper arm sockets onto the wiper motor shafts and secure the
wiper arm sockets with the flange nuts. Install the wiper arm caps over
the flange nuts.
C. Connect the washer hose to the wiper assembly.
3. If the wiper blade was removed, secure the blade to the wiper arm assembly
with the 2 bolts and 2 lock washers.
Figure 334) and 2 lock washers that secure the
8–10).
Figure 334) was removed, apply bead of
8–11).
Page 8–31
Removing the
Figure 334.
(Figure
Installing the Roof
Operator Cab: Service and Repairs