Testing the Electrical Components
Fusible Link Harness
Groundsmaster 360
16225SL Rev C
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g., unplug the key switch connector
before doing a continuity check of the switch).
Note: For engine component testing information; refer to the Yanmar Engine
Service Manual or Troubleshooting Manual.
When testing the electrical components for continuity with a
multimeter (ohms setting), ensure that you disconnect the power to
the circuit.
g186536
1.
Fusible link harness
g033658
The Groundsmaster 360 machine uses 3 fusible links for the circuit protection.
These fusible links are located in a harness that connects the starter B+ terminal
to the main wire harness. If any of these links fail, current to the protected circuit
IMPORTANT
Figure 193
Figure 194
Page 5–49
Electrical System: Testing the Electrical Components