Toro Groundsmaster 360 Service Manual page 330

Testing the Fuel Pump Capacity (continued)
Electrical System: Testing the Electrical Components
3. Disconnect the fuel hose (pump discharge) from the inlet fitting of the
fuel/water separator.
4. Place the disconnected fuel hose into a large, graduated cylinder sufficient
enough to collect 0.9 L (32 fl oz).
When testing the fuel pump, do not turn the key switch to the S
position.
5. Turn the key switch to the O
cylinder. Allow the pump to run for 30 seconds and then turn the switch to
the O position.
FF
Note: The amount of fuel pumped in 30 seconds must be approximately
350 ml (11.8 fl oz).
6. Ensure that the fuel hoses attached to the fuel pump, fuel/water separator,
and fuel tank suction tube screen are free of obstructions.
7. Replace the fuel pump if necessary.
8. Connect the fuel hose to the fuel/water separator. Ensure to secure the fuel
hose with the hose clamp.
9. Prime the fuel system; refer to
Fuel Pump Specifications
Pump Capacity
Pressure
Maximum Current Draw
10. Lower the hood and secure it with the latches.
IMPORTANT
position and collect the fuel in the graduated
N
Priming the Fuel System (page
700 ml/minute (23.5 fl oz/minute)
22.8 kPa (3.3 psi)
0.9 A
Page 5–94
TART
3–17).
Groundsmaster 360
16225SL Rev C