Toro Groundsmaster 360 Service Manual page 178

Assembling the Transmission (continued)
Hydraulic System: Service and Repairs
19. Carefully place the gear case housing onto the pump housing and align
the pins, pipe, and shaft bearings.
20. Assemble the gear case housing to the pump housing with the 15 flange-head
screws. Tighten the screws evenly in a crossing pattern and then torque the
screws to 23 to 26 N∙m (17 to 19 ft-lb).
21. Install the oil seal into the gear case housing bore.
Note: Ensure that you do not damage the input shaft oil seal.
22. Place the spacer on the oil seal and secure the seal with the retaining ring.
g033437
1. Hex plug
23. Lubricate new O-rings and install the O-rings onto the 3 plugs. Install the
plugs into the transmission assembly; torque the hex plugs to 19 to 20 N∙m
(14 to 15 ft-lb) and socket-head plug to 23 to 26 N∙m (17 to 19 ft-lb).
g033436
1. Oil seal
2. Thrust plate
24. Install the oil seal into the bore of the pump housing at the PTO shaft.
Figure 117
2. Socket-head plug
Figure 118
3. Thrust plate bevel
4. Control arm
Page 4–120 Groundsmaster 360
16225SL Rev C