High Flow Hydraulic Filter Kit; Hydraulic Test Fitting Kit - Toro Groundsmaster 360 Service Manual

High Flow Hydraulic Filter Kit

Hydraulic Test Fitting Kit

Hydraulic System: Special Tools
g035050
Toro Part No. TOR6011
The high flow hydraulic filter kit is designed with large flow (150 L/minute or 40
gallons/minute) and high pressure (34,500 kPa or 5,000 psi) capabilities. This
kit provides for bi-directional filtration which prevents filtered unwanted material
from entering into the circuit regardless of flow direction.
If a component failure occurs in the closed loop traction circuit, contamination
from the damaged part will remain in the circuit until you remove it. Install a
high flow hydraulic-fluid filter into the circuit when you connect the hydraulic test
gauges in order to test the traction circuit components or after you replace a
failed traction circuit component (e.g., piston pump or wheel motor). This filter
removes contamination from the hydraulic fluid in the traction circuit, thereby
preventing additional component damage.
Note: This kit does not include the hoses; refer to
4–29).
Note: The replacement filter element is Toro Part No. TOR6012. The filter
element cannister tightening torque is 34 N∙m (25 ft-lb).
g036472
Toro Part No. TOR4079
Figure 37
Figure 38
Page 4–30
Hydraulic Hose Kit (page
Groundsmaster 360
16225SL Rev C