Toro Groundsmaster 360 Service Manual page 154

Installing the Transmission (continued)
Hydraulic System: Service and Repairs
ports; refer to Installing the Hydraulic Fittings (SAE Straight Thread O-Ring
Fitting into the Component Port) (page
values identified in
3. If removed, install the gear pump to the transmission; refer to
Gear Pump (page
4. Lubricate the gasket of new oil filter and install the filter on the transmission.
5. Apply a thick layer of anti-seize lubricant to the splines of the transmission
input shaft and flywheel coupler.
6. Carefully place the 2 dowel pins (item 16 in
housing. Ensure that the dowel pins are perpendicular to the face of housing
during installation.
Ensure that you do not damage the transmission, flywheel housing,
hydraulic lines, electrical harness, or other parts while installing the
transmission.
The weight of the transmission is approximately 41 kg (90 lb).
Support the transmission assembly when you install it to the flywheel
housing to prevent it from falling and causing personal injury.
7. Support the transmission to prevent it from shifting.
8. Lower the transmission into the machine. Align the transmission input shaft
with the flywheel coupler and slide the transmission to the flywheel housing.
It may be necessary to turn the engine crankshaft to help align the splines of
the transmission shaft and coupler.
9. Assemble the transmission to the flywheel housing with the 7 bolts (items 10
and 12 in Figure 73) and 7 lock washers. Ensure that the shorter (35 mm)
bolt (item 10 in Figure
N∙m (400 in-lb).
10. Install the 2 bolts (item 19 in
the driveshaft to the transmission.
11. On both sides of the machine, attach the screw and flange nut that secures
the link assembly to the transmission control arm
Note: The bolt is installed from the inner side of the control arm.
12. Carefully position the seat channel to the frame
channel to the frame with 2 screws, 2 flat washers, and 2 flange nuts.
13. Remove the caps or plugs that were installed to the hydraulic hoses and
fittings during the removal process.
14. Use the labels that you attached during the removal process to correctly
connect the hydraulic hoses to the transmission, gear pump, and hydraulic
tank fittings; refer to
Seal Fitting) (page
4–9). Tighten the fittings to the torque
Figure 76.
4–137).
IMPORTANT
CAUTION
73) is properly positioned. Torque the bolts to 45
Figure 73), 2 locknuts, and roll pin that secures
Installing the Hydraulic Hose and Tube (O-Ring Face
4–8).
Page 4–96
Installing the
Figure 73) in the flywheel
(Figure 74).
(Figure 75). Secure the seat
Groundsmaster 360
16225SL Rev C