Product Overview; Controls; Operation; Operating The Edger - Toro 08766 Operator's Manual

Product Overview

Controls

Handle
Use the handle to raise and lower the edger
Figure 10
1. Handle
Alignment Guide
Loosen the adjustment screw and move the alignment guide
to the desired position (Figure
1. Adjustment screw
(Figure
11).
Figure 11
2. Alignment guide

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Operating the Edger

10).
1. Start the engine.
2. Press outward on the handle and lower the edger blade
to the ground
3. Engage the blade by pulling up on the Remote
Hydraulics control knob
1. Remote hydraulics control knob
4. Slowly move forward, not traveling faster than 1 to 2
mph.
5. To stop the edging operation:
•
Press outward on the handle and raise the edger
blade to the transport position
•
Disengage the blade by pushing down on the
Remote Hydraulics control knob
Adjusting the Edger Blade
Depth
1. Move the throttle control to the Slow position and
rotate the ignition key to Off and remove the key from
the switch to prevent accidental starting.
2. Raise the edger to the transport position.
3. Remove the scraper rod from the roller shaft
13).
10
(Figure 10).
(Figure 12).
Figure 12
(Figure
(Figure
10).
12).
(Figure