Using The Alignment Guide - Toro 08766 Operator's Manual

Figure 13
1. Roller
2. Roller shaft
4. Remove the roller shaft from the roller
5. Move the roller to the desired depth and install the
shaft. Start at the low setting 1/2 to 1-1/2 inches.
Note: Moving the roller down will raise the cutting
depth.
6. Lock the roller in position with the scraper rod.

Using the Alignment Guide

The alignment guide is used to keep the edger in a straight
line by sight or when following a string line.
1. Loosen the screw and adjust the alignment guide for or
aft to the desired position
2. Align the guide with the string or line desired to be
edged.
3. Tighten the screw.
3. Scraper rod
(Figure 13).
(Figure 11).
11