General Information; Control Locations And Functions - Toro UTV500AAC00000 Operator's Manual

General Information

Control Locations and
Functions
Ignition Switch Key
Two keys come with this vehicle. Keep
the spare key in a safe place.
Ignition Switch
The ignition switch has three positions.
OFF position — All electrical circuits
except the accessory are off. The engine
will not start. The key can be removed in
this position.

NOTE: The accessory plugs are
powered by the battery at all times.
RUN position — The ignition circuit is
complete and the engine can run. The key
cannot be removed in this position.
START position — The ignition circuit
is complete and the starter is engaged.
When the key is released, the switch will
return to the RUN position. The key can-
not be removed in this position.

NOTE: This vehicle has safety
interlock switches which prevent
the starter motor from activating
when the transmission is not in
neutral. Depress and hold the brake
pedal to engage starter when the
transmission is not in neutral.
Shift Lever
This vehicle is equipped with a constant
velocity transmission (CVT) coupled to a
dual-range transmission with reverse and
park.
24
Drive Select Switch
500
ATV-0056A
700
This switch allows the operator to oper-
ate the vehicle in either two-wheel drive
(rear wheels) or four-wheel drive (all
wheels) as well as mechanically lock the
differential (700 only) to apply equal
power to both front wheels. For normal
riding on flat, dry, hard surfaces, two-
wheel drive should be sufficient. In situa-
tions when additional traction is neces-
sary, four-wheel drive would be the
desired choice.
TC037
TC023A
HDX108C