Reverse Override Switch; Accelerator Pedal; Headlight Switch - Toro UTV500AAC00000 Operator's Manual

To select 2WD, depress the bottom of the
switch. To select 4WD, move the switch
to the middle position. To engage the dif-
ferential lock, slide the switch latch
slightly downward while pressing the top
of the switch forward.
CAUTION
Do not attempt to either engage or
disengage the front differential while
the vehicle is moving.

NOTE: On the 700 only when the
differential lock is engaged, the indi-
cator light will be illuminated.
! WARNING
The differential lock is intended for use
where minimum traction is available.
NEVER EXCEED 16 kph (10 MPH) with
the front differential lock engaged.
Maneuverability and handling charac-
teristics will differ with the differential
lock engaged. Control loss can result
in serious injury or death.
Foot Brake
The foot brake is the only service brake,
and it should be applied whenever brak-
ing is needed.
Apply the brake by pressing the brake
pedal down.

Headlight Switch

Use the headlight switch to select the
high or low headlight beam. When the
switch is in the HI position, the high
beam will illuminate. When the switch is
in the LO position, the low beam will
illuminate.

Reverse Override Switch

This vehicle is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch located on the
dash.

NOTE: The vehicle must be in 4WD
to activate the reverse override.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control could result.

Accelerator Pedal

Press down on the pedal to increase
engine RPM and vehicle speed; release
the pedal to decrease engine RPM and
vehicle speed.

NOTE: This vehicle is equipped
with an RPM limiter that retards
ignition timing
RPM is approached. When the RPM
limiter is activated, it could be mis-
interpreted as a high-speed misfire.
Seat
1. To remove the seat, lift up on the
front of the seat; then slide it forward.
2. To lock the seat into position, slide
the rear of the seat into the seat retain-
HDX108A
ers and push down firmly on the front
of seat. The seat must engage the
retainers and lock into position.
! WARNING
Make sure the seat is secure before
driving the vehicle. Serious injury or
death could result if the seat is not
properly secured.
HDX108B
when maximum
25