Jacking The Vehicle - Toro 07200 Operator's Manual

CAUTION
Only qualified and authorized personnel shall be
permitted to maintain, repair, adjust or inspect the
vehicle.
Avoid fire hazards and have fire protection equip-
ment present in the work area. Do not use an open
flame to check the level or leakage of fuel, battery
electrolyte or coolant. Do not use open pans of
fuel or flammable cleaning fluids for cleaning
parts.
Many maintenance procedures require raising and
lowering the bed. The following precautions must
be taken or serious injury or death could result.
WARNING
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake and
remove key from the ignition switch. Any load
material must be removed from bed or other
attachment before working under raised bed.
Always rotate safety support to the down position
before working under raised bed.
After maintenance is completed, remove the safety
support, slide it onto storage stud and lower the bed.
USING THE BED SAFETY
SUPPORT
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from storage stud on
top of the back rest support channel on the
Workman (Fig. 23).
3. Push the bed support onto the cylinder rod, mak-
ing sure support end tabs rest on the end of the
cylinder barrel and on cylinder rod end (Fig. 24).
4. To store the bed support, remove bed support
from cylinder and insert on stud on top of back
rest support channel.
5. Always install or remove bed support from out-
side of bed.
6. Do not try to lower bed with bed safety support
on cylinder.
Figure 23
1. Bed support
Figure 24
1. Bed support
2. Cylinder barrel

JACKING THE VEHICLE

1. Do not start the engine while the vehicle is on
jack, because engine vibration or wheel move-
ment could cause the vehicle to slip off the jack.
2. Do not work under the vehicle without jack
stands supporting it. The vehicle could slip off
jack, injuring any one beneath it.
3. The jacking point at the front of the vehicle is
under the front center frame support and at the
Maintenance
2. Storage stud
3. Bed
33