Toro 07200 Operator's Manual page 9

FULL BED REMOVAL (Model
07202 only)
1. Start the engine. Engage the hydraulic lift lever
and lower the bed until the cylinders are loose in
the slots. Release the lift lever and turn off the
engine.
2. Remove the Iynch pins from the outer ends of
the cylinder rod clevis pins (Fig. 1).
1.
Lynch pin
2. Cylinder rod end
3. Clevis pin
3. Remove the clevis pins securing the cylinder rod
ends to the bed mounting plates by pushing the
pins toward the inside (Fig. 2).
4. Remove the Iynch pins and clevis pins securing
the pivot brackets to the frame channels (Fig. 2).
5. Lift the bed off the vehicle.
CAUTION: The full bed weighs approximately
210 pounds, so do not try to install or remove it
by yourself. Get the help of two or three other
people.
6. Store the cylinders in the storage clips. Engage
the hydraulic lift lock lever on the vehicle to pre-
vent accidental extension of the lift cylinders.
Figure 1
Bed mounting plate
5. Rear slots (Full bed)
6. Front slots (2/3 bed)
RE-INSTALLING THE FULL BED
(Model 07202 only)
Note: If bed sides will be installed on the flat
bed, it is easier to install them before
installing the bed on the vehicle.
Note: Assure the rear pivot plates are bolted to
the bed frame/channel so that the lower
end angles to the rear (Fig. 2).
4.
1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
4. Clevis pin
5. Lynch pin
Note: Make sure spacer brackets and wear
blocks (Fig. 3) are installed or the radia-
tor cover may be damaged.
Figure 2
9