Toro 07200 Operator's Manual page 38

Maintenance
be identified by a "+" sign on top of battery
cover.
WARNING
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in the
vehicle, observe the following warnings:
• Never jump start with a voltage sources greater
than 15 volts D.C. This will damage the elec-
trical system.
• Never attempt to jump start a discharged bat-
tery that is frozen. It could rupture or explode
during jump starting.
• Observe all battery warnings while jump start-
ing your vehicle.
• Be sure your vehicle is not touching the jump
start vehicle.
• Connecting cables to the wrong post could
result in personal injury and/or damage to the
electrical system.
Figure 44
1. Positive (+) cable
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other vehi-
cle. The negative terminal has "NEG" on the bat-
tery cover. Do not connect the other end of the
jumper cable to the negative post of the dis-
charged battery. Connect it to the engine. Do not
connect the jumper cable to the fuel system.
4. Start the engine in the vehicle providing the
jump start. Let it run a few minutes, then start
38
your engine.
5. Remove the negative jumper cable first from
your engine, then the battery in the other vehicle.
6. Reinstall battery cover to battery base and tight-
en knobs.
IDENTIFICATION AND
ORDERING
MODEL AND SERIAL NUMBERS
The WORKMAN ® has two identification numbers: a
model number and a serial number. These numbers
are stamped into a plate located on the right frame
member under dash. In any correspondence concern-
ing the unit, supply the model and serial numbers to
ensure correct information and replacement parts are
obtained.
To order replacement parts from an authorized
TORO Distributor, supply the following information:
1. Model and serial numbers.
2. Part number, description, and quantity of parts
desired.