Table of Contents
Advertisement
C
C
LIP
ONTROL
B
C
LADE
OUNT
C
(FOC)
LIP
A
BOUT
Menu Item
M
ODEL
SN
TEC 5001
I
C
NFO
ENTER
CU1
CU2
CU3
G
ENERATOR
CAN B
US
Adjusting the Center Cutting Unit Raise/Lower Delay
Adjust the raise and lower delay time for the center cutting
with the InfoCenter, as desired from 1 to 10 according to the
table below. The factory default setting is 6 (375 ms) and is
optimized for a 3.8 mph mow speed.
Increment Number
1
2
3
4
5
6
7
8
9
10
Adjusting the Tap-off Delay
The tap-off delay feature allows the cutting units to turn off
without raising, and you may adjust it with the InfoCenter.
Turns the automatic
clip-control feature O
/O
.
N
FF
Set the number of blades in
each reel. This setting is only
necessary if C
C
LIP
ONTROL
set to O
.
N
Sets the desired clip. This
setting is only necessary if
C
C
is set to O
.
LIP
ONTROL
N
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the software revision of
the first cutting unit.
Lists the software revision of
the second cutting unit.
List the software revision of
the third cutting unit.
Lists the serial number of the
generator.
Lists the machine
communication bus status.
Delay Time (Seconds)
0.100
0.150
0.200
0.250
0.300
0.375
0.475
0.600
0.750
0.925
The delay setting represents the maximum time for the
raise/lower joystick to remain in the raise position to activate
this feature. The factory default setting is 1 which disables
this feature.
is
Increment Number
1
2
3
4
5
6
7
8
9
10
Setting the Clip-Control Feature
To achieve a consistent, high quality-of-cut and a uniform
after cut appearance, the machine has a clip-control feature
that varies the speed of the reels with the speed of the
machine, to maintain a constant clip. This feature is O
default; configure it and turn it O
1. From the S
2. Set C
C
LIP
ONTROL
3. From the S
4. Set the B
LADE
in each of your reels.
5. From the S
6. Set C
(FOC) to the desired clip setting.
LIP
Setting the Reel Speed
The clip-control feature automatically sets the reel speed
to match the machine speed. If you choose not to use the
clip-control feature, set the reel speed manually as follows:
1. Select the height-of-cut at which the cutting units are
set.
2. Choose the desired ground speed best suited for
conditions.
3. Using the appropriate graph
14 blade cutting units, determine the proper reel speed
setting.
20
Delay Time (Seconds)
Off
0.050
0.100
0.150
0.200
0.250
0.300
0.350
0.400
0.450
as follows:
N
menu, select C
ETTINGS
LIP
to O
.
N
menu, select B
ETTINGS
LADE
C
to match the number of blades
OUNT
menu, select C
ETTINGS
LIP
(Figure
16) for 5, 8, 11, or
by
FF
C
.
ONTROL
C
.
OUNT
(FOC)
Advertisement
Table of Contents
